crwdns2915892:0crwdne2915892:0
If your Nanit Pro N301 is not producing any sound or the sounds are dull, use this guide to replace the speaker. Some of the pieces are very small so make sure you have a tool that can grab tiny materials if you are unable to do so with your fingers. Make sure your device is not plugged in and connected to a power source during the repair.
crwdns2942213:0crwdne2942213:0
-
-
Insert an opening pick into the seam between the front and rear case.
-
Slide the opening pick around the perimeter of the camera until all of the retaining clips are released.
-
Separate the front and rear case.
-
-
-
Remove the four 4 mm T6 Torx screws from each corner of the circuit board.
-
Lift the circuit board out of the chassis.
-
-
-
-
Remove the two screws that secure the speaker with a T3 Torx screwdriver.
-
-
-
Use tweezers to disconnect the speaker motherboard connection.
-
Remove the speaker.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
IUPUI, Team 3-1, Harley Spring 2024 crwdns2935289:0IUPUI, Team 3-1, Harley Spring 2024crwdne2935289:0
IUPUI-HARLEY-S24S3G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
