crwdns2915892:0crwdne2915892:0
Replacing the screen isn't so much difficult as a lengthy process. There will be a lot of screws removed and a lot of parts coming off, so keep track of everything.
crwdns2942213:0crwdne2942213:0
-
-
Place the monitor face down on a clean, flat surface.
-
-
-
Firmly remove the back panel of the stand by pulling it up and away from the monitor.
-
-
-
Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.
-
-
-
Firmly grasp the stand enclosure with your hand and slide it to base of stand.
-
-
-
Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.
-
-
-
Lift the the stand straight up to remove it.
-
-
-
-
Place the monitor screen face up.
-
Pull the frame off by placing your fingers on the inside of the frame and pulling out and up, the frame should snap off.
-
Continue your way around the screen.
-
-
-
Unscrew the two 7mm screws from the bottom of the button assembly.
-
Pull the button assembly out a few inches and unplug the colored cables.
-
-
-
Unscrew the gold colored 7mm Phillips PH000 screw holding the button assembly to the monitor.
-
Remove the button assembly from the monitor.
-
-
-
With the monitor face-down, unscrew the 5 7mm Phillips PH2 screws around the outside of the enclosure.
-
-
-
Unscrew the 2 14.5mm Phillips PH2 screws located on the raised center of the enclosure.
-
Carefully pull the enclosure off the monitor.
-
-
-
Unscrew the 10 5mm Philips PH2 screws holding the metal casing to the monitor.
-
-
-
Pull the the metal casing off of the monitor to reveal the motherboards.
-
-
-
Unplug the pink and light blue attachments from the side of the brown board by pulling up on the tabs and gently pulling the cord out.
-
-
-
Unplug the 3 multicolored cables from the blue board by gently wiggling them back and forth while pulling up.
-
-
-
Unscrew the 4 5mm Phillips PH2 screws on the sides of the monitor.
-
-
-
Begin opening the enclosure by slowing pulling up on back panel of the monitor.
-
-
-
Unplug the cable from the screen. It is still attached by a fragile black belt.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 11-36, Amido Fall 2013 crwdns2935289:0Cal Poly, Team 11-36, Amido Fall 2013crwdne2935289:0
CPSU-AMIDO-F13S11G36
crwdns2931471:05crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Thank you very much for this tutorial. The steps are very specific and detailed. I bought a new NEC LCD1770NX LCD Display Screen online and installed it according to the steps in the article. Finally, the machine worked normally again. Thank you very much.
