crwdns2915892:0crwdne2915892:0
The power circuit board controls the flow of power to the monitor to prevent overload. If there is a problem with the power supply, the entire circuit board must be removed before any soldering may occur.
crwdns2942213:0crwdne2942213:0
-
-
Place the monitor face down on a clean, flat surface.
-
-
-
Firmly remove the back panel of the stand by pulling it up and away from the monitor.
-
-
-
Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.
-
-
-
Firmly grasp the stand enclosure with your hand and slide it to base of stand.
-
-
-
Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.
-
-
-
Lift the the stand straight up to remove it.
-
-
-
Place the monitor screen face up.
-
Pull the frame off by placing your fingers on the inside of the frame and pulling out and up, the frame should snap off.
-
Continue your way around the screen.
-
-
-
-
Unscrew the two 7mm screws from the bottom of the button assembly.
-
Pull the button assembly out a few inches and unplug the colored cables.
-
-
-
Unscrew the gold colored 7mm Phillips PH000 screw holding the button assembly to the monitor.
-
Remove the button assembly from the monitor.
-
-
-
With the monitor face-down, unscrew the 5 7mm Phillips PH2 screws around the outside of the enclosure.
-
-
-
Unscrew the 2 14.5mm Phillips PH2 screws located on the raised center of the enclosure.
-
Carefully pull the enclosure off the monitor.
-
-
-
Unscrew the 10 5mm Philips PH2 screws holding the metal casing to the monitor.
-
-
-
Pull the the metal casing off of the monitor to reveal the motherboards.
-
-
-
Make a note or use a pen to mark which plugs correspond to which colors. (Pink or Blue)
-
Remove the four plugs on the brown circuit board by pulling up on the tabs and wiggling them out. You could also use a spudger to help you lift little clips holding them in.
-
-
-
Locate the several multi-wire connectors on the board.
-
Disconnect the three plastic connectors from the blue colored boards by pulling them up while wiggling them.
-
-
-
Locate the large black power plug.
-
Using a Phillips #1 Screwdriver, unscrew the two 8mm colts holding the black tabs to the metal frame.
-
-
-
Locate and remove the gold colored 10mm Philips screw located near the black power plug. It holds in a wire that connects to the power plug.
-
-
-
Remove 5 8mm Phillip1 screws, with a Philips 1 screwdriver, located in various places on the board.
-
-
-
Lift the brown power supply board off of the frame and set it aside.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 11-36, Amido Fall 2013 crwdns2935289:0Cal Poly, Team 11-36, Amido Fall 2013crwdne2935289:0
CPSU-AMIDO-F13S11G36
crwdns2931471:05crwdne2931471:0
crwdns2935297:07crwdne2935297:0
