crwdns2942213:0crwdne2942213:0
-
-
Place the monitor face down on a clean, flat surface.
-
-
-
Firmly remove the back panel of the stand by pulling it up and away from the monitor.
-
-
-
Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.
-
-
-
Firmly grasp the stand enclosure with your hand and slide it to base of stand.
-
-
-
Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.
-
-
-
Lift the the stand straight up to remove it.
-
-
-
-
Place the monitor screen face up.
-
Pull the frame off by placing your fingers on the inside of the frame and pulling out and up, the frame should snap off.
-
Continue your way around the screen.
-
-
-
Unscrew the two 7mm screws from the bottom of the button assembly.
-
Pull the button assembly out a few inches and unplug the colored cables.
-
-
-
Unscrew the gold colored 7mm Phillips PH000 screw holding the button assembly to the monitor.
-
Remove the button assembly from the monitor.
-
-
-
With the monitor face-down, unscrew the 5 7mm Phillips PH2 screws around the outside of the enclosure.
-
-
-
Unscrew the 2 14.5mm Phillips PH2 screws located on the raised center of the enclosure.
-
Carefully pull the enclosure off the monitor.
-
-
-
Unscrew the 10 5mm Philips PH2 screws holding the metal casing to the monitor.
-
-
-
Pull the the metal casing off of the monitor to reveal the motherboards.
-
-
-
Carefully insert the prying tool underneath the power supply fuse.
-
Using the prying tool, lift the power supply fuse out of its emplacement until it is resting on its clamps.
-
-
-
Carefully remove the power supply fuse by hand.
-
-
-
Place the replacement power supply fuse on the fuse clips.
-
With a finger, press down on the ends of the replacement fuse until it is properly seated in the fuse clips.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 11-36, Amido Fall 2013 crwdns2935289:0Cal Poly, Team 11-36, Amido Fall 2013crwdne2935289:0
CPSU-AMIDO-F13S11G36
crwdns2931471:05crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Thanks for sharing the step by step procedure. It will be helpful to provide the model/type of the replacement fuse so that we can order it in advance and have it ready to replace the bad one while the monitor is open.
