crwdns2915892:0crwdne2915892:0
As this replacement guide works on an internal component of the Xoom Wifi, completion of prior steps to remove external parts is necessary.
crwdns2942213:0crwdne2942213:0
-
-
There are two 6.6 mm screws that hold ports into place as well as the back panel. Remove these with a T5 Torx screwdriver.
-
-
-
Apply light pressure with hand and slide the back plate till it stops in this position.
-
There is a flex clip on both sides that need to be pushed down in order for the plate to slide off completely. Use a plastic opening tool to release the flex clips. They are located under the back cover near the sides.
-
As soon as the clips are released the back should slide off.
-
-
-
-
Remove last two 4.2 mm screws from the remaining back piece with a T5 Torx screwdriver.
-
Once both screws are taken out, lift the rest of the backing out of the way.
-
-
-
Remove the two battery leads with a T-5 Torx screwdriver.
-
Grab the red and black wires with your fingers and gently lift to disconnect black wire connector from the motherboard.
-
-
-
All that holds the battery in are twelve screws. Remove them with a T-6 Torx screwdriver.
-
The battery should lift out easily.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 3-39, Maness Spring 2014 crwdns2935289:0Cal Poly, Team 3-39, Maness Spring 2014crwdne2935289:0
CPSU-MANESS-S14S3G39
crwdns2931471:04crwdne2931471:0
crwdns2935297:016crwdne2935297:0
crwdns2947410:01crwdne2947410:0
does anyone know what the function of the black and red wires are? my connector came off the motherboard.
