crwdns2915892:0crwdne2915892:0
To complete this guide you will need a pair of tweezers, a Torx T-6 screw driver, and a wedge to pry with. Before you start be sure to turn off the phone, remove the battery, and find a clean, water free work space.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four rubber stoppers around the main screen with tweezers.
-
-
-
Use a Torx T6 screwdriver to remove the 4 screws around the screen.
-
-
-
-
Use a plastic opening tool to separate outer shell from metal interior cover by sliding it along the crease in the case.
-
-
-
Use a plastic opening tool to separate the inner metal cover from the circuit board. Apply pressure to remove the piece.
-
-
-
Remove rubber covering over the camera.
-
Carefully remove camera and the attached orange ribbon by gently pulling on it. Pull out in the direction of the blue arrow. You can use your fingers or tweezers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.