crwdns2915892:0crwdne2915892:0
The front faceplate protects the components inside the radio. To replace inside components, the front faceplate of the radio must be removed. Follow the steps below to properly open the radio.
crwdns2942213:0crwdne2942213:0
-
-
Remove the back battery cover by pressing the tab to the left, and lifting.
-
-
-
Remove the batteries currently in the radio.
-
The orientation of the batteries is specified in the battery compartment.
-
-
-
Turn the Volume knob to the off position.
-
-
-
-
Firmly grasp and pull back on the volume knob. The knob should come off smoothly.
-
-
-
Remove the four 3 millimeter T6 Torx screws from the front of the radio.
-
-
-
Remove the four 3 millimeter T8 Torx screws from the back of the radio.
-
-
-
Gently open the backplate of the radio. Use a flathead screwdriver to slowly pry apart the two sides.
-
-
-
Gently pull the circuit board away from the front faceplate.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.