crwdns2915892:0crwdne2915892:0
This is a guide to replace the fingerprint sensor on the Moto G Power (2020). Follow these simple steps for a successful repair! If you encounter other issues, refer to our troubleshooting page.
Before you begin, download the Rescue and Smart Assistant app. This will allow you to back up your device and determine if your problem is software or hardware-related.
-
-
Position a suction cup securely on the back panel of the device.
-
Insert the opening pick into both sides of the phone and carefully slide it along to open the back panel of the device.
-
-
-
Apply gentle pressure to the fingerprint sensor with your finger to detach it from the back panel.
-
-
-
Fully remove the back panel from the device.
-
-
-
-
Using a Torx T3 screwdriver, remove nine 2.2 mm screws.
-
-
-
Use the spudger to gently lift the cover.
-
Set the back cover aside.
-
-
-
Carefully use the spudger to lift the sensor cable, disconnecting the fingerprint sensor from the motherboard.
-
-
-
Carefully remove the fingerprint sensor from the device and set it aside.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0