crwdns2915892:0crwdne2915892:0
If the front screen of your E815 is cracked or broken, you need to replace the screen. In most cases, a cracked screen is clearly visible by ink blots or radiating shatter patterns throughout the screen.
In this guide, you will:
- Dissemble the E815
- Access the front screen
- Replace the screen
crwdns2942213:0crwdne2942213:0
-
-
Locate the back cover release slide.
-
Use your finger to slide it down.
-
-
-
Remove the back cover by pulling it away from the phone.
-
-
-
Locate the battery removal slot.
-
Use your finger to pull the battery out from the top.
-
Remove the battery.
-
-
-
Locate the antenna port on the top of the phone.
-
-
-
Grip the plastic support post and unscrew the apparatus using a counterclockwise twist.
-
Pull the apparatus up and out of the phone.
-
-
-
-
Locate the two screws on the backside of the phone.
-
Unscrew the two screws using your T6 screwdriver.
-
-
-
Grasp the top of the phone near the speaker.
-
Gently pull the top section of the phone upwards until you feel some resistance.
-
Locate the brown connector that runs from the top section of the phone to the circuit board under the keypad.
-
Using tweezers, gently pry the connector from the circuit board.
-
Detach the top section of the phone from the keypad section.
-
-
-
Carefully insert the blue pry tool into the notch between the two halves of the top section of the phone.
-
Gently pry the two halves apart.
-
-
-
Rotate the top section of the phone around so that you are looking at the outer screen.
-
Disconnect the cover from the outer screen side of the phone.
-
-
-
Rotate the top section of the phone around so you are looking at the large screen.
-
Using your fingers, lift the protector off of the screen.
-
-
-
Using the blue pry tool, gently remove the screen cover.
-
-
-
Turn the phone so that you can see the side metal clasps.
-
Using the blue lifter tool, snap the metal clasps off of screen body.
-
Proceed to snap all four corners of the metal cover off of the screen body.
-
-
-
Using tweezers, gently detach the brown connecting strip from the back of the screen.
-
Separate the screen from the phone frame.
-
The front screen can now be accessed and replaced!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 14-8, Forte Winter 2011 crwdns2935289:0Cal Poly, Team 14-8, Forte Winter 2011crwdne2935289:0
CPSU-FORTE-W11S14G8
crwdns2931471:05crwdne2931471:0
crwdns2935297:05crwdne2935297:0
