crwdns2915892:0crwdne2915892:0
This guide can be used to replace the front speakers of Monster Soundstage S2 speaker.
crwdns2942213:0crwdne2942213:0
-
-
Use a spudger or your fingers to pry off and remove the rubber pad on the bottom of the speaker.
-
-
-
Remove the five 10mm screws with a TR 10 screwdriver.
-
Use a spudger to break the remaining adhesive holding the grille to the speaker body.
-
-
-
Flip speaker around and use a plastic opening tool to remove the top panel from the speaker.
-
-
-
Use a plastic opening tool to remove the foam and uncover four more screws.
-
Use a TR 10 screwdriver to remove the five 10mm screws on the top of the speaker.
-
-
-
-
Use a TR 10 screwdriver to remove two of the 10mm screws that secure the speaker grille.
-
-
-
With the top panel removed, use a spudger to remove the display panel.
-
Use a TR 10 screwdriver to remove the four final 10mm screws securing the speaker grille.
-
-
-
After removing grille, you will see the speakers.
-
Remove the eight 10mm screws that surround the speakers. There will be four around each speaker.
-
-
-
Carefully lift each speaker from the housing. It may be necessary to break a light adhesive seal.
-
Set each speaker beside the main housing.
-
-
-
Carefully but firmly unplug the two wires from each driver.
-
The front speakers can now be removed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 21-5, Maness Winter 2017 crwdns2935289:0Cal Poly, Team 21-5, Maness Winter 2017crwdne2935289:0
CPSU-MANESS-W17S21G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Does anybody know what size driver the rear woofer is and resistance, would like to repair an s3 for a friend in cuba who received a used one as a gift
