crwdns2915892:0crwdne2915892:0
This quick guide will help you disassemble a Mitsubishi T200 phone, install a new screen, and reassemble your device.
crwdns2942213:0crwdne2942213:0
-
-
Begin disassembling the phone by removing the phone back cover and battery.
-
-
-
To remove the back plate, loosen and remove the four screws by using a #00 Philips head screwdriver.
-
-
-
Separate the front plastic component from the motherboard component.
-
-
-
Take the circuit board off the motherboard.
-
-
-
-
Unclip the four clips to remove the screen (connected to the clear plastic) from the circuit board.
-
-
-
Remove the attached ribbon from the circuit board by prying open the gray plastic clip at the top right of the circuit board.
-
-
-
We can now insert the new screen and reassemble the device.
-
Place the ribbon of the new screen into the clip on the top right of the circuit board.
-
-
-
Clip the new screen onto the circuit board.
-
-
-
Replace circut board back on top of motherboard.
-
-
-
Take the entire internal assembly and join it with the front plastic housing.
-
-
-
Join the phone's face assembly to the back plastic housing. Make sure you carefully insert the front into the antenna's clip first.
-
Snap the whole unit together.
-
-
-
Firmly replace screws into the backing.
-
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0