crwdns2915892:0crwdne2915892:0
Use this guide to replace the Milwaukee Sawzall 6520-21 cord. This provides power to the saw and requires replacement over time.
This guide requires one screwdriver handle and two bits:
- Size 20 Torx
- 1.5mm Flathead
crwdns2942213:0crwdne2942213:0
-
-
Unplug the Sawzall and Orient the right half-handle to face upwards.
-
With a T20 Torx screwdriver, remove the following screws:
-
7-18 x 1.125-inch Slt. Plastite T-20
-
8-16 x .625-inch Slt. Plastite T-20
-
Lift the handle off.
-
-
-
-
Remove the screw above the trigger.
-
8-16 x .625-inch
-
-
-
Take a 1.5mm flathead screwdriver and insert it into the pin lock above each of the wires:
-
Black wire: Insert it on the left side of the pin. Pull the wire while gently rotating it clockwise
-
Black wire: Insert it on the bottom side of the pin and gently rotate it counterclockwise
-
White wire: Insert it on the right of the pin and gently rotate it counterclockwise
-
To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
crwdns2915084:0crwdne2915084:0
Cuesta, Team 10-1, Krynen Fall 2024 crwdns2935289:0Cuesta, Team 10-1, Krynen Fall 2024crwdne2935289:0
CUESTA-KRYNEN-F24S10G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:04crwdne2935297:0
