crwdns2915892:0crwdne2915892:0
If the Milwaukee 2605-20 Drill is not allowing orientation switching, follow this guide to inspect and replace the forward/reverse shuttle.
The screws on this device are not easily removed.
crwdns2942213:0crwdne2942213:0
-
-
Remove the battery by sliding it from the base.
-
-
-
Remove two 20.3 mm screws at the right side of the drill base using a Torx T3 screwdriver.
-
-
-
Remove five 20.3 mm screws on the right side of the handle using a Torx T3 screwdriver.
-
-
-
-
Remove four matte 24 mm screws on the crankcase at the rear cover of the drill (connecting the chuck to the handle) using a Torx T3 screwdriver.
-
-
-
Remove two 24 mm screws on the housing cover beneath the ventilation slots. These screws point into the drill.
-
-
-
Using a Torx T5 screwdriver bit, remove two 26.8 mm screws on each side of the drill housing cover, located beneath the ventilation slots. These screws point upwards.
-
-
-
Gently pry apart the covers for the drill handle.
-
-
-
Locate the forward/reverse shuttle on the drill, just behind the drill trigger mechanism.
-
Gently pull the trigger down and remove the damaged fwd/rev shuttle.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
University of Memphis, Team 3-3, Sneed Spring 2024 crwdns2935289:0University of Memphis, Team 3-3, Sneed Spring 2024crwdne2935289:0
UM-SNEED-S24S3G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:08crwdne2935297:0
