crwdns2915892:0crwdne2915892:0
This guide shows the owner of the scanner how to replace the two bulbs located in the upper lid of the scanner.
crwdns2942213:0crwdne2942213:0
-
-
Loosen the screws on the serial port by turning them counter clockwise by hand.
-
After loosening the screws, pull the serial port out.
-
-
-
Lift lid to its vertical position.
-
Pull lid straight up to remove it from the scanner.
-
-
-
-
Notice that there are two plastic tabs that need to be pushed in to remove the plastic covering.
-
Use tweezers to push these tabs in.
-
Gently pull the plastic covering off of the upper lid.
-
-
-
Grab the plastic wire housing near the serial port.
-
Gently pull and jiggle the wire housing until it comes free from the circuit board.
-
-
-
Gently lift up the bulbs and remove the wires from the plastic.
-
After completely freeing the bulbs, buy new ones and replace.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 6-9, Regan Fall 2011 crwdns2935289:0Cal Poly, Team 6-9, Regan Fall 2011crwdne2935289:0
CPSU-REGAN-F11S6G9
crwdns2931471:02crwdne2931471:0
crwdns2935297:022crwdne2935297:0
