crwdns2915892:0crwdne2915892:0
In the event that the buttons on the side of the Microsoft Band 2 become jammed or unresponsive, follow this guide to learn how to remove them for cleaning or replacement.
crwdns2942213:0crwdne2942213:0
-
-
Use a heatgun to melt the adhesive beneath the screen. Heat the metal around edges of the screen.
-
-
crwdns2935267:0crwdne2935267:0Spudger$2.99
-
Use a spudger and plastic opening picks to pry the screen away from the Band 2.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use metal tweezers to gently detach the orange press-fit (or "pop") connector.
-
-
-
Use the T3 Torx Screwdriver to remove the two 2.7 mm screws
-
-
-
Lift the logic board and locate the two circular clips securing the buttons from inside the wall of the Band 2. Remove them by sliding the clips sideways.
-
-
-
Remove the buttons, being careful not to lose the springs.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0