crwdns2915892:0crwdne2915892:0
This guide demonstrates how to replace the buttons on the Miadore Classic N64 Controller. If the buttons are damaged or just misaligned, this guide can help solve your issue. This guide can also be used if you just want to change the buttons with custom buttons.
Before you replace the buttons, you may want to review the Miadore Classic N64 Controller Buttons are Unresponsive troubleshooting page for tips on how to resolve your issue.
Unplug the controller from your device before you begin this repair.
crwdns2942213:0crwdne2942213:0
-
-
Unscrew all nine 3.2 mm Phillips #000 screws from the back of the controller.
-
Remove the back panel of the controller.
-
-
-
Remove the three 3.2 mm Phillips #000 screws holding the motherboard in place.
-
-
-
Remove the three 3.2 mm Phillips #000 screws holding the joystick module in place.
-
Remove the joystick module.
-
-
-
Remove the joystick by pulling it away from the needle-like object holding it in place.
-
Replace it with a new or custom joystick.
-
-
-
Remove the right and left bumper.
-
-
-
Pull the motherboard up with even pressure on all sides.
-
Set the motherboard to the side.
-
-
-
Remove the rubber pads. This will reveal the buttons underneath.
-
-
-
Remove the buttons by pushing up from the bottom of the controller. This will cause them to pop out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
CSU Los Angeles, Team 5-3, Kershman Fall 2024 crwdns2935289:0CSU Los Angeles, Team 5-3, Kershman Fall 2024crwdne2935289:0
CSULA-KERSHMAN-F24S5G3
crwdns2931471:05crwdne2931471:0
crwdns2935297:02crwdne2935297:0
