crwdns2915892:0crwdne2915892:0
How to replace the valve plate in a Mi-T-M Air Compressor AM1-PH65-08HD 2012.
crwdns2942213:0crwdne2942213:0
-
-
Flip the engine switch into the OFF position.
-
-
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
Pull the ring on the safety relief valve away from the compressor tank to drain the air from the compressor.
-
-
-
Use a 7/8 inch wrench to loosen the nut securing the pump discharge line to the elbow on the cylinder head.
-
-
-
Remove the pump discharge line from the elbow.
-
-
-
Use a 10 mm socket to remove the bolt securing the belt guard.
-
-
-
-
Tilt the belt guard away from the device and lift it out to remove it.
-
-
-
Use a 7/16 inch socket to remove the nuts and accompanying bolts securing the belt guard bracket to the rear belt guard.
-
-
-
Use a 1/2 inch socket to remove the two bolts securing the belt guard bracket to the cylinder head.
-
-
-
Lift the belt guard bracket straight up to remove it.
-
-
-
Remove the four spacers from the top of the cylinder head.
-
-
-
Use a 1/2 inch socket to remove the four remaining bolts securing the cylinder head:
-
Two 2 1/8 inch-long bolts
-
Two 2 1/2 inch-long bolts
-
-
-
Remove the cylinder head.
-
-
-
Remove the gasket from the cylinder head.
-
-
-
Push up on one of the valve plate tabs to break the seal between the valve plate and the gasket.
-
Remove the valve plate.
-
-
-
Remove the bottom valve plate gasket from the top of the cylinder.
-
Use a shop towel to remove any remaining pieces of the gasket on top of the cylinder.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0