crwdns2915892:0crwdne2915892:0
Removing the PCB board requires a Phillips #1 screwdriver with at least a 15 cm shaft and a set of tweezers. Make sure there are no batteries in the device and that it is not plugged in before starting the procedure.
crwdns2942213:0crwdne2942213:0
-
-
Turn the clock radio over so the bottom is facing up.
-
Pull the tab upward and remove the cover from the battery compartment.
-
Remove the batteries.
-
-
-
Remove the five screws on the bottom of the device with a screwdriver.
-
Grasp the top and bottom and gently pull apart.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the (5) 7mm screws with a Phillips #1 screwdriver and a pair of tweezers.
-
-
-
Locate the wiring harness.
-
Disconnect the wiring harness using the tweezers.
-
-
-
Remove the PCB board from the device.
-
Replace the broken motherboard with a new PCB board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.