crwdns2915892:0crwdne2915892:0
This guide will provide instructions for removing the speaker and mic in a Maze Speed phone. You will need a plastic opening tool, screwdriver, tweezers and soldering equipment. You should know how to solder to avoid damaging other components in the phone.
crwdns2942213:0crwdne2942213:0
-
-
With the phone face down, remove the back cover with the plastic opening tool. For easiest access, insert the plastic opening tool in the bottom left corner.
-
-
-
After the back cover is removed, remove the battery, sim cards, and micro SD card. These components are highlighted in red.
-
-
-
-
Using the screwdriver, remove fourteen 2mm screws to access the internal casing of the phone.
-
After the screws are removed, use the plastic opening tool to remove the internal casing cover.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Locate the wire that attaches the motherboard to the daughter-board of the speaker and mic. Using tweezers, disconnect the wire from the motherboard.
-
-
-
Using your soldering tools, un-solder both set of wires that are connected to the daughter-board.
-
You may now replace the old speaker and mic with new accessories.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Embry-Riddle Aeronautical University, Team S3-G3, Watkins Summer 2019 crwdns2935289:0Embry-Riddle Aeronautical University, Team S3-G3, Watkins Summer 2019crwdne2935289:0
ERAU-WATKINS-SU19S3G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
