crwdns2915892:0crwdne2915892:0
This guide describes how to replace the camera and or gimbal for the Mavic 2 drone.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two 2x5 mm screws from the plastic piece near the camera on bottom side using the Allen key.
-
-
-
Remove plastic part from previous step.
-
-
-
Remove ribbon cable connecting to camera by pulling at camera connection point.
-
-
-
-
Unscrew 1.5 x 4.5 mm gimbal mount screw using Allen key.
-
-
-
Use Allen key to remove screws holding nose plate, in the front left and right corners in front of the camera.
-
-
-
Remove four rubber parts from camera mount.
-
-
-
Remove camera from frame by pulling apart.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.