crwdns2915892:0crwdne2915892:0
This repair may be necessary, as the eyes in the T-Rex can easily break or stop lighting up. In order to begin this repair, all you need is a small JIS #1 screwdriver, wire cutter, LED bulb, and a small pair of tweezers.
crwdns2942213:0crwdne2942213:0
-
-
Open the jaw of the T-Rex to reveal the screw on the roof of its mouth.
-
-
-
Using a JIS #1 screwdriver, remove the 9.6mm screw.
-
-
-
-
Using tweezers or wire cutters for tension, remove the cover to reveal the LED assembly.
-
-
-
Remove the plastic cover from the top of the LED.
-
-
-
Hold the LED to remove slack from the wires, and cut the wires as shown to remove the faulty LED.
-
To reassemble your device, follow these instructions in reverse order. Use a soldering station to solder new LED onto the fresh-cut wires.
To reassemble your device, follow these instructions in reverse order. Use a soldering station to solder new LED onto the fresh-cut wires.
crwdns2915084:0crwdne2915084:0
IUPUI, Team S3-G3, Harley Spring 2018 crwdns2935289:0IUPUI, Team S3-G3, Harley Spring 2018crwdne2935289:0
IUPUI-HARLEY-S18S3G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
