crwdns2915892:0crwdne2915892:0
This is a prerequisite guide for the removal of the power cord in a Makita jack hammer HM1307CB. If you need to replace the power cord, follow the cord replacement guide.
crwdns2942213:0crwdne2942213:0
-
-
Remove the black Phillips screw from the strain relief plate.
-
Loosen the two silver Phillips screws that hold the stripped ends of the power cable in the green terminal on the controller. These screws do not need to be removed.
-
-
-
-
Remove the power supply cord from the jack hammer.
-
First, compress the wire ends so they are relatively flat.
-
Then, insert each wire end into the green terminal, noting the polarity of the cables: the black cable should go into the upper slot, and the white cable should go into the lower slot (as shown in the third photo of this step).
-
Finally, gently tighten the screws until the wires are secured.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
