crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Makita Jack Hammer HM1307CB Controller Cover Removal

crwdns2862623:0crwdne2862623:0
crwdns2942641:0crwdne2942641:0

crwdns2915892:0crwdne2915892:0

This guide is a prerequisite and is not meant to be used on its own! These steps illustrate the removal of the controller cover in a Makita HM1307CB jack hammer.

crwdns2942213:0crwdne2942213:0

  1. Makita Jack Hammer HM1307CB Controller Cover Removal, Remove two hex screws: crwdns2935265:01crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Remove the two hex screws holding the controller cover in place.

    • During reassembly, clean the residual threadlocker from these screws, then reapply high-strength (red) threadlocker to each one before reinstalling.

    crwdns2913378:0crwdne2913378:0

  3. Makita Jack Hammer HM1307CB Controller Cover Removal, Remove the controller cover: crwdns2935265:02crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Makita Jack Hammer HM1307CB Controller Cover Removal, Remove the controller cover: crwdns2935265:02crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • Remove the controller cover and the attached power supply cord from the jack hammer.

    crwdns2913378:0crwdne2913378:0
crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order.

crwdns2862417:0crwdne2862417:0

crwdns2935291:0crwdnd2935291:01crwdnd2935291:0crwdne2935291:0

Taylor Dixon

crwdns2935283:006/26/18crwdne2935283:0

70 009 crwdns2915208:0crwdne2915208:0

crwdns2935297:094crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 40

crwdns2935301:037crwdne2935301:0

crwdns2947412:00crwdne2947412:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 1

crwdns2936753:07crwdne2936753:0 1

crwdns2936753:030crwdne2936753:0 2

crwdns2942667:0crwdne2942667:0 53