Makita DT01 Trigger Switch Replacement
crwdns2944107:0crwdnd2944107:0Victoria Sciracrwdnd2944107:0crwdnd2944107:0crwdnd2944107:03crwdnd2944107:0crwdne2944107:0
crwdns2944111:0May 7, 2024crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0This will teach you how to replace your trigger switch on your Makita DT01 drill.
crwdns2942213:0crwdne2942213:0
crwdns2943215:0crwdne2943215:0
-
-
Lay the device down on its side.
-
-
-
Pinch the indents on both sides of the battery.
-
-
-
Pull the battery out of the drill
-
Recharge or completely replace the battery
-
-
-
Unscrew all six 15mm screws with a JIS1 screwdriver bit.
-
-
-
Remove the top of the plastic drill case
-
-
-
Remove the bottom of the plastic drill case
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use your tweezers to remove the black wire from the motor
-
-
-
Use your tweezers to remove the red wire from the motor
-
-
-
Your trigger switch should now be removed from your motor
-
-
-
Use your tweezers to remove the red and black wires from the two-pronged plug
-
-
-
Your trigger switch is now detached from the device
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
