crwdns2915892:0crwdne2915892:0
A guide to accessing the GPS sensor.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four rubber caps from the back by using the Phillips #00 screwdriver.
-
-
-
Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.
-
-
-
Remove the back cover from the device by separating the back cover along its seam.
-
-
-
-
Pull the speaker cord, horizontally, by its base, away from the motherboard.
-
-
-
Remove the two screws on that are located on opposite sides of the board.
-
-
-
Lift up the circuit board and disconnect the GPS wire, pulling horizontally from its connector port.
-
-
-
Carefully flip the circuit board out so you can get to the sensor easily.
-
Remove the tape holding the sensor to the display and take out the sensor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0