crwdns2915892:0crwdne2915892:0
Use this as a guide to remove or replace the rubber part of the directional pad.
crwdns2942213:0crwdne2942213:0
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use tweezers to completely remove the sticker from the rear of controller.
-
-
-
Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
-
-
-
Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.
-
Use the plastic opening tool to pry the two cases apart.
-
-
-
-
Locate RS-DP-LS switch.
-
Pull upwards on the switch to remove it.
-
-
-
Locate the four 8.3 mm Phillips screws on the circuit board and remove them.
-
-
-
Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use tweezers to remove the rubber part of the directional pad.
-
-
-
Insert a new directional pad over the original directional pad's location.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 1-7, Propen Fall 2012 crwdns2935289:0Cal Poly, Team 1-7, Propen Fall 2012crwdne2935289:0
CPSU-PROPEN-F12S1G7
crwdns2931471:04crwdne2931471:0
crwdns2935297:014crwdne2935297:0
crwdns2947412:02crwdne2947412:0
mi spiegate l'utilita di questa guida?vendere forse le pinzette e tutte le altre stronzatine che servono per riparare il fightpad?quando invece il pezzo più importante cioè il gommino non lo vendete....fate pena
Hi I don't speak Italian but I think you are asking "what is the purpose of this guide?". We made these as a project for university because I wanted to resolder a wire in this controller that came undone. For good measure we made a guide for each individual part although the real purpose of these guides was for the full disassembly and re soldering.
