crwdns2915892:0crwdne2915892:0
This guide is an internal private guide used as a prereq.
crwdns2942213:0crwdne2942213:0
-
-
Remove two 11 mm Phillips screws securing the hard drive bracket to the upper case.
-
-
-
Lift the retaining bracket out of the upper case.
-
When putting the bracket back after replacing the drive, it is easy to put in backwards. If it doesn't seat smoothly, then reverse it and try again.
-
-
-
-
Lift the hard drive by its pull tab and pull it away from the upper case, minding the cable still attaching it to the logic board.
-
-
-
Remove the hard drive cable by pulling its connector straight away from the hard drive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.