crwdns2915892:0crwdne2915892:0
Replacing the hard drive on a Unibody is simple - it only requires removing one screw!
crwdns2942213:0crwdne2942213:0
- 
   
   
- 
                     
            
With the case closed, place the Unibody top-side down on a flat surface.
 - 
                     
            
Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.
 
 - 
                     
            
 - 
   
   
- 
                     
            
The access door should now be raised enough to lift it up and out of the Unibody.
 
 - 
                     
            
 - 
                     
                                                
 - 
   
   
- 
                     
            
Grab the white plastic tab and pull the battery up and out of the Unibody.
 
 - 
                     
            
 - 
   
   
- 
                     
            
Remove the single Phillips screw securing the hard drive bracket to the upper case.
 
 - 
                     
            
 - 
   
   
- 
                     
            
Lift the hard drive by its pull tab enough to grab and remove the retaining bracket.
 - 
                     
            
Lift the hard drive out of the chassis, minding the cable attaching it to the computer.
 
 - 
                     
            
 - 
   
   
- 
                     
            
Remove the hard drive from its cable by pulling the cable connector straight away from the drive.
 - 
                     
            
Hard drive remains.
 
 - 
                     
            
 
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.