crwdns2894164:0crwdne2894164:0

crwdns2892376:0crwdne2892376:0

Prereq for right fan and display assembly to disconnect and peel back airport and camera cables

crwdns2860947:0crwdne2860947:0

crwdns2890040:0crwdne2890040:0

  1. Use a spudger or tweezers to pry the three AirPort antenna cables straight up off of their sockets on the AirPort board, and bend them up and out of the way. The cable connection points are very fragile. Be careful to lift only on the connector, and not on the socket or cable. To reconnect, align the connector carefully into position over the socket, and press it down firmly with the flat of your spudger.
    • Use a spudger or tweezers to pry the three AirPort antenna cables straight up off of their sockets on the AirPort board, and bend them up and out of the way.

    • The cable connection points are very fragile. Be careful to lift only on the connector, and not on the socket or cable.

    • To reconnect, align the connector carefully into position over the socket, and press it down firmly with the flat of your spudger.

  2. Peel the right rubber cover up off the fan and fold it out of the way. Peel the right rubber cover up off the fan and fold it out of the way.
    • Peel the right rubber cover up off the fan and fold it out of the way.

  3. Use the tip of a spudger to push the camera cable connector out of its socket on the logic board. Be sure to push parallel to the board, pushing first on one side, then the other to "walk" the connector out of its socket.
    • Use the tip of a spudger to push the camera cable connector out of its socket on the logic board.

    • Be sure to push parallel to the board, pushing first on one side, then the other to "walk" the connector out of its socket.

  4. Use your fingers to pull the AirPort/Camera cables up off the fan. The cables are adhered to the fan, so peel them up carefully to avoid damaging them. Carefully de-route the cables from the plastic cable guide.
    • Use your fingers to pull the AirPort/Camera cables up off the fan.

    • The cables are adhered to the fan, so peel them up carefully to avoid damaging them.

    • Carefully de-route the cables from the plastic cable guide.

    • On reassembly, there should be enough adhesive still on these cables to stick them back down to the fan.

crwdns2892372:0crwdne2892372:0

To reassemble your device, follow these instructions in reverse order.

crwdns2878480:0crwdne2878480:0

Andrew Optimus Goldheart

crwdns2886885:017/10/2009crwdne2886885:0

475 237 crwdns2894548:0crwdne2894548:0

crwdns2886889:0410crwdne2886889:0

crwdns2892814:0crwdne2892814:0

iFixit crwdns2886886:0iFixitcrwdne2886886:0

Community

crwdns2858115:0136crwdne2858115:0

crwdns2886889:016 677crwdne2886889:0

crwdns2892924:00crwdne2892924:0

crwdns2892926:0crwdne2892926:0

crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 3

crwdns2894768:030crwdne2894768:0 5

crwdns2894770:0crwdne2894770:0 276