crwdns2915892:0crwdne2915892:0
This guide has been updated by iFixit staff! Read the new, official guide here.
crwdns2942213:0crwdne2942213:0
-
-
Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody:
-
Red Seven 3 mm Phillips screws.
-
Orange Three 13.5 mm Phillips screws.
-
-
-
Slightly lift the lower case and push it toward the rear of the computer to free the mounting tabs.
-
-
-
Remove the following tri-wing screws securing the battery to the upper case:
-
Red One 5.5 mm tri-wing screw
-
Orange One 13.5 mm tri-wing screw.
-
-
-
-
Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.
-
-
-
Lift the battery out of the upper case
-
-
-
Remove the ribbon cable by releasing it from the ZIF connector on the underside of the trackpad and also from the socket that attaches it to the logic board.
-
-
-
Remove the four 1.2mm #00 Phillips head screws from rear of the trackpad.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:08crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Master Techs crwdns2935289:0Master Techscrwdne2935289:0
Community
crwdns2931471:0327crwdne2931471:0
crwdns2935297:01.673crwdne2935297:0
crwdns2947412:02crwdne2947412:0
I had better luck using the #000 Phillips to get the 1.2mm screws out during step 7.
I accidentally disabled my track pad in the system preferences how do I enable it again when the trackpad wont click?
