crwdns2915892:0crwdne2915892:0
Prereq only.
crwdns2942213:0crwdne2942213:0
-
-
Use the flat end of a spudger to pry the SSD cable connector up from its socket on the logic board.
-
-
-
Use your thumb or finger to bend the plastic spring bar on the SSD tray, freeing the two clips at the front side of the device.
-
While holding the spring bar depressed, tilt the SSD assembly up out of its cavity.
-
-
-
-
Remove the SSD assembly from the upper case.
-
-
-
Remove the single 2.9 mm T5 Torx screw securing the SSD to the SSD tray.
-
-
-
Insert the edge of plastic opening tool between the SSD and the SSD tray, opposite to the socket side of SSD tray.
-
Pry the side of the SSD opposite the SSD tray socket out of the SSD tray.
-
-
-
Carefully pull the SSD straight out of its socket on the SSD tray.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0