crwdns2937539:0crwdnd2937539:0crwdne2937539:0
crwdns2942213:0crwdne2942213:0
-
-
Disconnect the port hatch ribbon cable from the logic board by pulling it straight up by its black pull tab.
-
Pull the audio out ribbon cable off the adhesive securing it to the upper case.
-
Use a spudger to pry the audio out ribbon cable connector board off the hard drive bracket.
-
-
-
Disconnect the audio out cable from its socket on the port hatch ribbon cable.
-
-
-
-
Use a spudger to pry the hard drive cable connector up off the logic board.
-
-
-
Use the sharp end of a spudger to de-route the microphone cable from the hard drive bracket.
-
Remove the cosmetic screw cover from the adhesive securing it to the hard drive bracket.
-
-
-
Remove the four Phillips screws securing the hard drive assembly to the upper case:
-
Two 4.7 mm screws.
-
Two 3.9 mm screws.
-
-
-
Lift the hard drive assembly out of the upper case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.