crwdns2915892:0crwdne2915892:0
Prerequisite only guide to remove the inner plate from the Mac mini (2024).
crwdns2942213:0crwdne2942213:0
-
-
Fully shut down your Mac mini and unplug all cables from it.
-
Flip over your Mac mini and place it on a clean, flat surface to avoid scratching the chassis.
-
-
-
Insert a Jimmy into the gap between the bottom cover and the chassis.
-
Pry up the bottom cover to create a gap.
-
Keep the Jimmy inserted under the bottom cover.
-
-
-
Insert an opening pick into the gap created by the Jimmy.
-
Remove the Jimmy.
-
-
-
Slide the opening pick along the bottom cover until you feel it snag on a clip.
-
Twist the pick to lift the clip out of its slot.
-
-
-
Continue sliding and prying with the pick along the perimeter of the bottom cover to release the remaining clips.
-
-
-
Lift the edge of the bottom cover opposite the power button and flip it over to expose the power button cable.
-
-
-
-
Grip the power button cable close to the head and pull it away from its socket to disconnect it.
-
-
-
Remove the bottom cover.
-
-
crwdns2935267:0crwdne2935267:0FixMat$36.95
-
Use a T5 Torx screwdriver to remove the twelve screws securing the inner plate:
-
Eight 3.4 mm‑long screws
-
Four 2.4 mm‑long screws
-
-
-
Insert the point of a spudger into one of the clips' slots on the inner plate.
-
Pry up the inner plate enough so you can grip the edge along the same side as the headphone jack.
-
-
-
Pull the inner plate away from the chassis to slide it out from under the lip on the heat sink.
-
-
-
Lift the inner plate and flip it over to expose the wireless module cable.
-
-
-
Use one hand to secure the wireless module during this step.
-
Use a Torx Plus 5IP screwdriver to remove the four 2.5 mm‑long screws securing the wireless module cover.
-
-
-
Remove the wireless module cover.
-
-
-
Use one hand to secure the wireless module during this step.
-
Insert the point of a spudger under one of the short edges of the wireless module press connector.
-
Pry up to disconnect the wireless module.
-
-
-
Remove the inner plate.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
