crwdns2942213:0crwdne2942213:0
-
-
Separate the back of the device from the face by inserting the flat end of the nylon spudger into the corner of the device to safely pry it open.
-
-
-
Use the nylon spudger to gently pry out the battery.
-
-
-
-
Solder the wires off that are on the battery. Use the solder technique guide for helpful tips!
-
-
-
Remove the 4.1 mm screws from the motherboard using the J #000 Phillips Screwdriver.
-
-
-
Carefully remove the tape connected to the back of the screen and the motherboard.
-
-
-
Use the nylon spudger to separate the screen from the plastic casing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0