crwdns2915892:0crwdne2915892:0
This guide is for replacing the LiPo Rechargeable Battery Logitech G Pro X Lightspeed. You battery may need to be replaced if your headset only turns on when plugged in or doesn't hold a long charge (factory spec is ~20 hours).
For your safety, discharge the battery below 25% before disassembling your device. Inspect batteries for physical and chemical damage. Battery should not be swollen to any extent. For non-OEM batteries, make sure your wires match with the original.
crwdns2942213:0crwdne2942213:0
-
-
Prepare headset. Remove mic and set power switch to off
-
Replacement part #533-000084. 1100mAh 3.7V 603450 Li-polymer battery
-
-
-
-
Using a Philips 00 driver, remove 4 screws.
-
-
-
Open headset and carefully remove adhesive holding battery
-
-
-
Remove single screw holding PCB in place using a Philips 000 driver.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Disconnect JST connector carefully using tweezers. Do NOT pull on the wires directly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
