crwdns2915892:0crwdne2915892:0
After a long use the joystick trigger might experience a lack of strength within the trigger's internal spring.
crwdns2942213:0crwdne2942213:0
-
-
Remove these three Phillips #1 screws:
-
Two 10mm screws.
-
One 7mm screw.
-
-
-
Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.
-
Remove the two 10mm Phillips #1 screws.
-
-
-
-
Pull apart the joystick chassis by hand.
-
Release this clip located underneath the hand rest
-
-
-
Remove the plastic trigger from the joystick.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0