crwdns2915892:0crwdne2915892:0
If your drive is having problems opening, the drive belt may have broken or fallen out of the track and you will need to replace it.
crwdns2942213:0crwdne2942213:0
-
-
Insert an open paper clip into the small hole on the left side of the faceplate.
-
After the tray opens, extend it fully.
-
-
-
Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate.
-
-
-
Pull the faceplate away from the main chassis.
-
-
-
-
Unscrew the four 8.5 mm screws on the bottom chassis using a Philips #2 screwdriver.
-
-
-
Lift the top and bottom chassis straight up in order to remove them.
-
-
-
Extend the tray so that the belt is accessible.
-
Remove the old belt using tweezers.
-
-
-
Carefully replace with the new belt by wrapping it around the larger gear first, followed by the smaller gear.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:05crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 6-5, Regan Fall 2011 crwdns2935289:0Cal Poly, Team 6-5, Regan Fall 2011crwdne2935289:0
CPSU-REGAN-F11S6G5
crwdns2931471:02crwdne2931471:0
crwdns2935297:06crwdne2935297:0
crwdns2917034:0crwdne2917034:0
In case anyone is interested, I used a 11/16” OD x 9/16” I.D. x 1/16” wall, for this exact drive (was a tight fit) and seems to work perfect.
I was so tired of replacing rubber bands every few months!
And yes this is an “O-ring” it should be less than a buck five eighty at your local big box hardware store.
