crwdns2942213:0crwdne2942213:0
-
-
Remove the two Phillips #000 screws.
-
-
-
Use a plastic iFixit opening tool to pry the edges of the back case loose by placing it in between the edge of the cover and the screen.
-
-
-
Use the spudger to reach into the center of the device and pry off the back case by giving it a light force upwards.
-
-
-
Remove one 5mm screw using the Phillips #00 Screwdriver.
-
-
-
Use the spudger to disconnect the camera and battery from the printed circuit board by putting the spudger in between the connections and the printed circuit board and pushing the spudger up.
-
-
-
Remove one 5mm screw with the Phillips #00 screwdriver.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use the nylon tip tweezers to push the camera out from between the power button and the kickstand.
-
-
-
Remove the four 1 mm screws with a Phillips #00 Screwdriver.
-
-
-
Use a spudger to disconnect the ribbon wire by applying a force upwards.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use tweezers to lift up the foil.
-
-
-
Use the tweezers to lift the black tape from the corner of the printed circuit board.
-
-
-
Flip the board 180 degrees towards you using the tweezers.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the wire from the PCB by pulling it towards the edge of the headphone jack using tweezers.
-
-
-
Remove the one 5mm screw using a Phillips #00 Screwdriver.
-
-
-
Using tweezers remove the tape to disconnect the module by pulling it upward.
-
-
-
Remove the yellow piece of tape by pulling it upward using tweezers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.