crwdns2915892:0crwdne2915892:0
This guide shows how to replace the fingerprint sensor on the Lenovo Yoga 920-13IKB.
crwdns2942213:0crwdne2942213:0
-
-
Remove the ten 5mm Torx T5 screws on the back cover to loosen the back cover.
-
-
-
Slide the iFixit Opening Tool under the back cover to lift it up.
-
Pull up on the cover with your hand to release the tab holding the center of the cover in place.
-
-
-
Remove the four 5mm Phillips #00 screws that hold the battery in place.
-
-
-
Grab the grouping of wires with your fingers close to the connector and gently pull to disconnect the battery from the motherboard.
-
-
-
-
Use the iFixit Opening Tool to lift the battery up enough to grab it with your hands.
-
-
-
Remove the 3mm Phillips #00 Screw to loosen the sensor.
-
-
-
Lift up the cover on the fingerprint sensor using the iFixit Opening Tool and remove the cover from the sensor.
-
-
-
Flip up the cable connector tab using the iFixit Opening Tool to release the ribbon wire.
-
-
-
Unplug the ribbon wire from the sensor to completely free the sensor.
-
-
-
Lift the fingerprint sensor with the iFixit Opening Tool and remove it from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.