crwdns2915892:0crwdne2915892:0
If your Lenovo Yoga 2 11" 20428 keyboard is not working (keys are getting stuck, keys aren't producing the correct symbols, etc.), use this guide to replace the keyboard.
Before using this guide, make sure your device is powered off and not connected to a power source.
crwdns2942213:0crwdne2942213:0
-
-
Flip the computer over so the bottom is facing up.
-
Remove the ten 6mm screws with a T5 Torx security screwdriver.
-
-
-
Carefully remove the back panel by gently separating the panel from front to back.
-
-
-
Use the Phillips #000 screwdriver to remove the six 3.3 mm screws around the perimeter of the battery.
-
Use the Phillips #000 screwdriver to remove the single 6.75 mm screw from the center of the battery.
-
-
-
Gently remove the three pieces of tape securing the Bluetooth/Wi-Fi antenna.
-
-
-
Grip the base of the connector with your fingers or pliers, and gently pull the connector straight back towards you to remove it.
-
-
-
Carefully remove the battery from the laptop.
-
-
-
Use the Phillips #000 screwdriver to unscrew the four 1.7 mm screws.
-
-
-
Carefully detach the speaker wire and remove the speaker.
-
-
-
Use the Phillips #000 screwdriver to remove the four 3.3 mm screws securing the hard drive to the panel.
-
-
-
-
Lift the hard drive up, turn it over, and remove the connection.
-
-
-
Use the Phillips #000 screwdriver to remove the two 3.3 mm screws.
-
-
-
Gently grab and remove the Bluetooth module.
-
-
-
Using your finger nail or a thin pry tool, unlock and remove the three cables.
-
Lift the two pieces of tape. Carefully pull the cable connector back to remove it from the motherboard.
-
Use the Phillips #000 screwdriver to remove the eight 3.8mm screws.
-
-
-
Gently pull the cable out of the connector.
-
-
-
Lift the wide cable in the center to reveal the port for the small cable underneath.
-
Using a fingernail or a thin pry tool, lift the white bar to release the cable.
-
Remove the cable from the connector.
-
-
-
Lift the tape up to separate it from the motherboard.
-
Using a fingernail or a thin pry tool, lift the connector upwards to separate from the motherboard.
-
-
-
Remove the black tape covering the connector.
-
Pull straight backwards to remove the connector from the motherboard.
-
-
-
Pull the cable straight backwards to remove it.
-
-
-
Pull the cable straight backwards to remove it.
-
-
-
Use the Phillips #000 screwdriver to remove the seven 3.6mm screws.
-
-
-
Lift and pull backwards to remove the motherboard.
-
-
-
Use the Phillips #000 screwdriver to unscrew and remove the one 3.3 mm screw that secures the daughterboard.
-
-
-
Carefully remove all of the small black clips along the edge of the metal piece.
-
-
-
Gently lift up and remove the two metal pieces, at the back of the bottom case, near the hinges.
-
-
-
Gently lift up the metal cover and remove it.
-
-
-
Gently lift up the keyboard base and remove it.
-
To reassemble your Lenovo Yoga 2 11" (model 20428) keyboard, follow these instructions in reverse order.
To reassemble your Lenovo Yoga 2 11" (model 20428) keyboard, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team 1-3, Harley Spring 2022 crwdns2935289:0IUPUI, Team 1-3, Harley Spring 2022crwdne2935289:0
IUPUI-HARLEY-S22S1G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
