crwdns2915892:0crwdne2915892:0
To remove the screen module off the laptop board follow the following steps
crwdns2942213:0crwdne2942213:0
-
-
Flip the computer upside down.
-
The red rectangle shows the location of the battery.
-
-
-
Locate the two switches that lock the battery. Push the left-hand switch outward into the "unlocked" position.
-
-
-
Now push and hold the right clip to the right while using your other hand to gently slide the battery away from the computer.
-
-
-
Locate the hard drive enclosure (marked by the red rectangle).
-
-
-
Use a small Phillips screwdriver to unscrew the single screw that holds down the hard drive enclosure cover.
-
Carefully remove the hard drive enclosure cover.
-
-
-
Gently pull the black pull tab out from above the hard drive. Continue pulling on the pull tab until the hard drive and the two plastic rails come out of the enclosure.
-
-
-
Remove the plastic rails from the old SSD/hard drive and place them on the new SSD/hard drive.
-
-
-
-
Once you have located the two screws, remove them with a small Phillips screwdriver.
-
-
-
Gently pull the strip out from the case.
-
-
-
Use a a plastic spudger (or a flat screwdriver) to push the keyboard towards the screen. This will pop the bottom of the keyboard out of the casing.
-
-
-
Carefully lift the keyboard so that you can access its connector.
-
-
-
Carefully unplug the connector by pulling.
-
-
-
You are done - the keyboard is not connected to the laptop any more and can be replaced.
-
-
-
Remove five 5.7mm screws from the bottom.
-
-
-
Unscrew two 5.7mm screws from the top of the bottom of the laptop.
-
-
-
Pull the palm rest off the laptop board.
-
-
-
Unlock the white seal and disconnect the blue cable.
-
-
-
Carefully disconnect blue and red cables and remove them from plastic case.
-
-
-
Unlock white seal and diconnect blue cable from upper corner.
-
-
-
Remove two 4.1mm screws from the black frame.
-
-
-
Carefully pull off black frame from laptop board.
-
-
-
Carefully lift the screen module straight up to detach from board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Texas Tech, Team 6-3, Bennett Fall 2016 crwdns2935289:0Texas Tech, Team 6-3, Bennett Fall 2016crwdne2935289:0
TTU-BENNETT-F16S6G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:03crwdne2935297:0
