crwdns2915892:0crwdne2915892:0
This will take approximately 50 minutes to complete from beginning to end.
crwdns2942213:0crwdne2942213:0
-
-
Close the device and flip it over to expose the back panel.
-
-
-
Use a Phillips #1 screwdriver to unscrew the five captive screws on the back panel until a small pop is heard.
-
-
-
-
Gently wedge an opening tool or spudger under the back panel, and loosen the clips around the perimeter until the back panel comes off.
-
Remove the back cover.
-
-
-
Using the Phillips #1 screwdriver, remove the four 5 mm screws that are holding the battery down.
-
Remove the battery.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use tweezers to gently unplug the CMOS Battery from the port on the right side.
-
-
-
Work the wire out from its holding brackets and is now free to be removed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0