crwdns2942213:0crwdne2942213:0
-
-
Gently insert a spudger into one of the bottom corners between the screen and body case.
-
Slide the spudger along the inside of the crack in order to pry the case open.
-
-
-
After removing the cover, remove the M1.6 x 2 mm screw from the battery cable with the JIS J000 screwdriver.
-
Remove the tape by gently scraping the edges up with the spudger.
-
-
-
Gently lift the flaps on the four ZIF connectors to disconnect the cables.
-
Use the plastic card to gently pry the battery from the device.
-
-
-
-
Use the tip of a spudger or your fingernail to flip up the small locking flap. Then, you can safely pull the cable out from under the camera.
-
-
-
Remove the press-fit cable located next to the camera by using opening tool to gently pry it up.
-
Unlock the ZIF connector by lifting the black bar and sliding the ribbon cable out.
-
-
-
Remove the five M1.6 x 2 mm screws from the motherboard with the JIS J000 screwdriver.
-
Cut or remove the piece of silver tape from the motherboard.
-
-
-
Use the spudger to gently pry the motherboard out of the frame from each side.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 3-6, Eyestone Fall 2015 crwdns2935289:0USF Tampa, Team 3-6, Eyestone Fall 2015crwdne2935289:0
USFT-EYESTONE-F15S3G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:011crwdne2935297:0
crwdns2917034:0crwdne2917034:0
hi James,great guide there, I've removed a motherboard from a similar levono tablet and made.good a broken usb port, but now the thing is charging and booting fine, but the screen is unresponsive. No display or touch operation, any ideas? Tia
