crwdns2915892:0crwdne2915892:0
Use this guide to replace the system board
crwdns2942213:0crwdne2942213:0
-
-
Look at the back of the tablet and locate the speakers on top of the rear cover.
-
There is a smaller indentation in the plastic cover that runs across the top of the device.
-
Wedge the plastic opening tool, under the middle of the cover as shown, then push up and the cover will pop off.
-
-
-
Remove two black 3mm Phillips #00 screws.
-
-
-
Disconnect battery power connector by pinching the connector with tweezers, and sliding it out of the housing.
-
-
-
Remove seven black 3mm Phillips #00 screws.
-
-
-
-
Now you can take the battery out in order to either replace it or continue disassembling the device.
-
-
-
Remove two black 3mm Phillips #00 screws.
-
Remove three silver 1.8 mm Phillips #00 screws.
-
-
-
Use tweezers to flip up the small black plastic locks on all four connections.
-
Carefully remove each of the exposed ribbons.
-
-
-
Disconnect the two speaker connectors by pinching them with tweezers and sliding them out from the system board housing.
-
-
-
Use tweezers or your finger nail to disconnect the camera attachment by flipping up the black rectangular connector.
-
-
-
Disconnect the HDMI connection with the system board
-
Use a plastic opening tool to pry up the system board, and you will hear a pop as it comes free.
-
Slide out the system board from its housing tab on the upper right corner.
-
Pull the board slowly away from the tab, and it will pop out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 7-19, Regan Spring 2014 crwdns2935289:0Cal Poly, Team 7-19, Regan Spring 2014crwdne2935289:0
CPSU-REGAN-S14S7G19
crwdns2931471:04crwdne2931471:0
crwdns2935297:015crwdne2935297:0
