crwdns2915892:0crwdne2915892:0
Use this guide to replace the digital board.
crwdns2942213:0crwdne2942213:0
-
-
Look at the back of the tablet and locate the speakers on top of the rear cover.
-
There is a smaller plastic cover that runs across the top of the device.
-
Wedge the blue opening tool, under the middle of the cover as shown, then push up and the cover will pop off.
-
-
-
Remove the following two screws:
-
M3.0 x 3.0 mm #00 phillips screws (black)
-
-
-
-
Once it is unscrewed, remove the rear cover
-
This may take a little force to get off but with enough force it should pop right off
-
Use a blue opening tool to pry it open
-
Slide the tool to one corner then grab another tool and slide it to the opposite corner
-
Pull the cover up and it will come off
-
-
-
Use the tweezer tool to flip up the three small plastic locks attached to the digital board.
-
Then, slide newly exposed ribbons out.
-
-
-
Remove the following two screws:
-
M5.3 x 1.75 mm #00 phillips screws (silver)
-
-
-
Once it is unscrewed, use the tweezer tool to pull the digital board straight out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 7-19, Regan Spring 2014 crwdns2935289:0Cal Poly, Team 7-19, Regan Spring 2014crwdne2935289:0
CPSU-REGAN-S14S7G19
crwdns2931471:04crwdne2931471:0
crwdns2935297:015crwdne2935297:0
