crwdns2915892:0crwdne2915892:0
This requires only a Phillips head screwdriver. Be aware that only 2.5" hard drives fit in this computer.
crwdns2942213:0crwdne2942213:0
-
-
Turn off the computer, unplug all cables, and let it cool down. Lay the computer flat on its screen.
-
-
-
Remove the monitor stand screw in the bottom of the stand, and remove the stand completely.
-
-
-
Remove the two screws on the bottom of the computer, one on each side.
-
-
-
-
Locate the slot on the right side of the computer next to the screw hole. Use a plastic opening tool or spudger to pry off the rear cover. (Don’t be afraid to use a little force.)
-
-
-
Once it has been separated, lift to remove.
-
-
-
Unscrew the four screws that secure the hard drive enclosure.
-
-
-
Unplug the SATA cable. Lift to remove the hard drive enclosure.
-
-
-
Unscrew the four screws that hold hard drive enclosure to the hard drive, located on the side of the enclosure.
-
-
-
Lift the hard drive up to remove it from the enclosure.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:012crwdne2935229:0
crwdns2947412:05crwdne2947412:0
you have been busy!!!!! Noticed the solutions , etc. below and that is impressive. chaosone7 @gmail.com
It’s nice and easy to get there, unfortunately the board was fried lol.
Can I replace the hard drive with a 1TB SATA III 6Gb/s 4-bit QLC V-NAND Flash 1GB Cache 2.5" Solid State Drive - Samsung QVO
The hard drive in this should be a 2.5” drive, so the replacement you listed should work
Do you have a better suggestion