Lenovo 300e Windows 2nd Gen Storage Card Replacement

crwdns2915892:0crwdne2915892:0

Please power off your device before the replacement.

Failure to do this may result in harm to yourself or the device.

By continuing with this replacement, you assume any loss of data, files, and other info on your device that may lost during the replacement. You are solely responsible.

There is no reason you may 'need' this replacement unless your device is dealing with some sort of corruption. Any other reasons may be personal reasons such as data transfer.

crwdns2942213:0crwdne2942213:0

crwdns2931653:01crwdne2931653:0 Remove the bottom panel.

Lenovo 300e Windows 2nd Gen Storage Card Replacement, Remove the bottom panel.: crwdns2935265:01crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

Flip the device upside down. Remove the bottom panel. Unscrew all 9 screws.
Some screws may not lift out of the panel. If this happens, simply loosen all screws and lift the entire panel off of the device.

crwdns2913378:0crwdne2913378:0

crwdns2931653:02crwdne2931653:0 Unscrew the Storage Card.

Lenovo 300e Windows 2nd Gen Storage Card Replacement, Unscrew the Storage Card.: crwdns2935265:02crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

Unscrew the screw holding the storage card in place.
Make sure you uncrew the right card. The card is located near the top. (assuming the battery is the closest to you) It isn't the one all the way at the top, it is below the one at the top and is slightly bigger.

crwdns2913378:0crwdne2913378:0

crwdns2931653:03crwdne2931653:0 Remove and replace the Storage Card.

Lenovo 300e Windows 2nd Gen Storage Card Replacement, Remove and replace the Storage Card.: crwdns2935265:03crwdnd2935265:01crwdnd2935265:02crwdne2935265:0

Lenovo 300e Windows 2nd Gen Storage Card Replacement, Remove and replace the Storage Card.: crwdns2935265:03crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

Carefully wiggle the storage card out of the port.
Insert your replacement storage card and put the screw back in.
The card may sit on top of the spot where the screw enters. This is okay, as long as it is only the orangish/brownish part.
Put on the back panel by putting the screws in their original places and tightening them.