crwdns2915892:0crwdne2915892:0
Use this guide in order to capture the essence of replacing your back camera, enabling you to capture the world!
crwdns2942213:0crwdne2942213:0
-
-
Before disassembling your LeapPad, ensure your device is shut off.
-
Push outward on the plastic side panels to remove and reveal battery.
-
The panels should detach fully from the main device.
-
-
-
Push down from the positive end of the battery towards the negative end to pry the battery up out of its dispenser.
-
Remove all four AA alkaline batteries from the device.
-
-
-
Remove the following screws securing the back cover to the main device:
-
Two 10.0 mm Phillips screws
-
Four 4.0 mm Phillips screws
-
Three 3.0 mm Phillips screws
-
-
-
-
Insert a plastic opening tool into the seam between the front and rear covers to detach the back cover from the rest of the device.
-
Move the plastic opening tool around the perimeter of the LeapPad2.
-
Lift up and remove the rear case from the tablet.
-
-
-
Locate the back camera below the game cartridge.
-
-
-
To safely remove the ribbon cable, first you must pull up the retaining flap.
-
-
-
Pull up using a thin plastic tool to disconnect the ribbon connecting the camera to the motherboard.
-
-
-
Gently remove the back camera from your motherboard by pushing the black casing away from the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 8-10, Regan Spring 2014 crwdns2935289:0Cal Poly, Team 8-10, Regan Spring 2014crwdne2935289:0
CPSU-REGAN-S14S8G10
crwdns2931471:04crwdne2931471:0
crwdns2935297:016crwdne2935297:0
