crwdns2915892:0crwdne2915892:0
This guide will show how to disconnect the sensor from the motherboard for replacement or repair. This guide is necessary if the device will not read any temperatures or is reading incorrect temperatures. The tools required are a screwdriver and soldering iron. Because a soldering iron presents a hazard, there is a link to a soldering guide in the Troubleshooting section of the device page.
crwdns2942213:0crwdne2942213:0
-
-
Pull the battery cover away from the handle by gripping near the thumb groove.
-
-
-
Gently pull the battery out of the handle.
-
-
-
Disconnect the battery by pulling the connector away from it.
-
Positive first
-
Negative second
-
-
-
Remove the battery cover from the device by pulling it straight out.
-
-
-
-
Using the plastic opening tool remove the front and rear yellow covers.
-
-
-
Remove the two 3.1 mm Phillips #0 screws.
-
-
-
Realign the buttons with the button terminals.
-
Red terminal to red button.
-
Orange terminal to orange button.
-
Yellow terminal to yellow button.
-
-
-
Carefully pull the trigger out.
-
-
-
Pull the motherboard out of its slot in the device.
-
-
-
Using a soldering iron, melt the solder that holds the wires for the sensor to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0