crwdns2942213:0crwdne2942213:0
-
-
Remove the two plastic screw covers below the inside phone screen.
-
-
-
Unscrew both screws using a Torx T6 screwdriver.
-
-
-
Pry off the screen front cover with a 3mm flathead screwdriver.
-
-
-
-
Pry off the speaker, which is glued onto the front cover, using a small flathead screwdriver.
-
-
-
Unsolder the black and red wires of the speaker from where they are attached to the base of the screen.
-
-
-
Obtain replacement speaker and solder the new black and red wires back to the base of the screen.
-
-
-
Apply glue to the back of the speaker and place it back in its original position.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 3-25, Regan Fall 2010 crwdns2935289:0Cal Poly, Team 3-25, Regan Fall 2010crwdne2935289:0
CPSU-REGAN-F10S3G25
crwdns2931471:04crwdne2931471:0
crwdns2935297:014crwdne2935297:0
